BVBPD - M0-086, MIL-C-22750E CLEAR, COMP A
- MSDS: BVBPD
- Manufacturer: CRAWFORD LABORATORIES INC
- Product Name: M0-086, MIL-C-22750E CLEAR, COMP A
- National Stock Number: 8010-01-313-8703
Product Identification
Product ID:M0-086, MIL-C-22750E CLEAR, COMP A
MSDS Date:07/21/1992
FSC:8010
NIIN:01-313-8703
Kit Part:Y
MSDS Number: BVBPD
Responsible Party
CHICAGO, IL 60609
US
Emergency Phone: 800-424-9300 CHEMTREC
Info Phone: 312-376-7132
Preparer: DAVID SCHMETTERER
Cage: DO165
Contractor
Telephone: 312-376-7132
Cage: 5V430
Ingredients
METHYL ETHYL KETONE (SARA III) (VAPOR PRESSURE 71.2 MM HG)
CAS: 78-93-3
RTECS: EL6475000
Fraction By Weight: 20%
OSHA PEL 100 PPM
ACGIH TLV: 200 PPM
EPA Report Quantity: 5000 LBS
DOT Report Quantity: 5000 LBS
BISPHENOL A-EPICHLOROHYDRIN RESIN
CAS: 25085-99-8
Fraction By Weight: 30%
TOLUENE (SARA III) (VAPOR PRESSURE 38 MM HG)
CAS: 108-88-3
RTECS: XS5250000
Fraction By Weight: 15%
OSHA PEL 100 PPM
ACGIH TLV: 100 PPM
EPA Report Quantity: 1000 LBS
DOT Report Quantity: 1000 LBS
BENZENE (SARA III) (TOLEUNE CONTAINS A TRACE OF BENZENE)
CAS: 71-43-2
RTECS: CY1400000
Fraction By Weight: TRACE
EPA Report Quantity: 10 LBS
DOT Report Quantity: 10 LBS
331 GPL
RTECS: 9999999VO
Hazards
Health Hazards Acute and Chronic:HEADACHE,DIZZINESS,NAUSEA,LOSS OF
CONSCIOUSNESS.SEVERE EYE IRRITATION POSSIBLY RESULTING IN PERMANENT
DAMAGE.IRRITATED MUCOUS MEMBRANES.VOMITING DUE TO INGESTN.DEFATTING
& DRYING OF SKIN.SENSITIZATION AFTER REPEATED CONTACT.UNLIKELY
THAT OPERATIONS W/RESIN COULD PRODUCE ATMOSPHERIC CONCENTRATN
APPROACHING OSHA LIMITS.
Explanation of Carcinogenicity:YOU SHOULD BE AWARE THAT IT HAS BEEN
REPORTED TO CAUSE CANCER IN LABORATORIES ANIMALS.
First Aid
First Aid:EYE:FLUSH W/LOW PRESSR WATER 15 MIN,LIFT EYELID.GET MED
AID.INHAL:REMOVE TO FRESH AIR.GIVE OXYGEN IF BREATH DIFFICULT.GIVE
ARTIF RESP IF NO BREATH.GET MED AID.KEEP WARM & COMFORTABLE.NEVER
GIVE UNCONS CIOUS PERSON LIQ.INGEST:CALL DR IMMED.ONLY INDUCE VOMIT
OF DR'S INSTRUCTN.IF VOMIT OCCURS,KEEP HEAD BELOW HIPS.NOTHING BY
MOUTH TO UNCONSCIOUS.SKIN:FLUSH W/WATER,THEN SOAP & WATER.IF IRRIT
GET MED AID
Fire Fighting
Flash Point Method:SCC
Flash Point:22.0F,-5.6C
Lower Limits:1.2
Extinguishing Media:FOAM, CO2, OR DRY CHEMICAL
Fire Fighting Procedures:WATER MAY BE USED TO KEEP EXPOSED CONTAINER
COOL, & KEEP FLAMMABLE STRUCTURES WET. DON'T ENTER FIRE AREA W/O
PROTECTION BECAUSE HAZARDOUS DECOMP MAY BE PRESENT.
Unusual Fire/Explosion Hazard:WATER PRESSURE MAY SPREAD A FLAMMABLE
LIQUID FIRE. SEALED CONTAINERS MAY EXPLODE IF OVERHEATED.
Accidental Release
Spill Release Procedures:WARNING--FLAMMABLE. ELIMINATE ALL IGNITION
SOURCES. HANDLING EQUIPMENT MUST BE GROUNDED TO PREVENT SPARKING.
SOAK UP WITH AN ABSORBENT AND PLACE IN NON-LEAKING CONTAINERS. SEAL
TIGHTLY FOR PROPER DISP OSAL.
Handling
Handling and Storage Precautions:FLAMMABLE.KNOW DOT REGS BEFORE
TRANSPORT.HOT ORGANIC CHEM VAPORS SUSCEPTIBLE TO SUDDEN SPONTANEOUS
COMBUSTION WHEN MIXED W/AIR.IGNITION MAY OCCUR AT**
Other Precautions:**TEMP BELOW AUTOIGNIT TEMP.IGNIT TEMP DECREASE
W/INCREASING VAPOR VOLUME & VAPOR/AIR CONTACT TIME & PRESSR
CHANGE.HOT VAPOR MAY IGNITE W/AIR BELOW AUTOIGNITN.IGNITN MAY OCCUR
AT HIGH TEMP W/SUDDEN IN GRESS OR ESCAPE OF VAPORS TO ATMOSPHERE.
Exposure Controls
Respiratory Protection:IMPORTANT-MUST PROVIDE ADEQUATE VENTILATION TO
MAINTAIN VAPOR CONCENTRATIONS BELOW ESTABLISHED TLV LIMIT AS GIVEN
BY OSHA. IN MORE CONFINED AREAS A NIOSH-MSHA APPROVED EQUIPMENT
WITH ORGANIC VAPOR CAR TRIDGE SHOULD BE WORN.
Ventilation:MUST PROVIDE ADEQUATE VENTILATION, SEE RESPIRATORY
PROTECTION.
Protective Gloves:USE RUBBER GLOVES.
Eye Protection:WEAR APPROVED SAFETY GOGGLES/FACE SHIELD
Other Protective Equipment:HAVE EYE BATH AND SAFETY SHOWER AVAILABLE.
Work Hygienic Practices:REMOVE CONTAMINATED CLOTHING AND SHOES. DO NOT
REUSE CONTAMINATED CLOTHING OR SHOES.
Supplemental Safety and Health
Chemical Properties
Boiling Pt:B.P. Text:174 TO 232F
Vapor Density:> AIR
Spec Gravity:1.03
Viscosity:>200 CS
Evaporation Rate & Reference:3.42 X N-BUTYL ACETATE
Solubility in Water:SLIGHT
Appearance and Odor:CLEAR LIQUID / SOLVENT ODOR
Percent Volatiles by Volume:40.0
Corrosion Rate:NOT CORR
Stability
Stability Indicator/Materials to Avoid:YES
MAY BE INCOMPATIBLE WITH OXIDIZING AGENTS AND STRONG ALKALIES.
Stability Condition to Avoid:AVOID HEAT, SPARKS, OPEN FLAMES AND
INCOMPATIBILITIES.
Hazardous Decomposition Products:INCOMPLETE COMBUSTION FOR PRODUCTS
LIKE THIS MAY GENERATE HIGHLY POISONOUS CARBON MONOXIDE AND OTHER
TOXIC GASES.
Disposal
Waste Disposal Methods:DISPOSAL MUST BE IN ACCORDANCE WITH CURRENT
LOCAL, STATE, AND FEDERAL REGULATIONS. CONTACT AN APPROVED DISPOSAL
FACILITY. EPA HAZARDOUS WASTE CODE: D001. HAZARDOUS WASTE
CHARACTERISTIC: IGNITABLE. DIS POSAL METHODS: FUEL CONSUMPTION.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.